Canon VB-M40 Security Camera User Manual


 
[Network] Administrator Password and LAN, IP Address, DNS and Other Settings
4-7
4
Setting Page
SNMP
1 [SNMP]
Set SNMP use to [Disable] or [Enable]. Camera
information can be referenced by the SNMP Manager if
[Enable] is specified.
2 [Community Name]
Set a community name for SNMP. It is recommended
that you change the community name to ensure system
security.
3 [Administrator Contact Information]
Set contact information (e-mail address, etc.) for the
Administrator of the camera. Setting information can be
referenced by the SNMP manager.
4 [Administration Function Name]
Set the camera name used for administration. Setting
information can be referenced by the SNMP manager.
If left blank, “VB-M40” will be used by default.
5 [Installation Location]
Set information regarding the installation location of this
camera. Setting information can be referenced by the
SNMP manager.
Note
The information set in the camera is read-only from the SNMP
manager.
Use the SNMP Manager that supports SNMP MIB2 (supporting
RFC1213).
Supports SNMP protocol versions v1 and v2c (v3
unsupported).