Filter
Top Products
144
E
Additional
Information
Miscellaneous
Cause and/or what to do about it
• The remote sensor mode is set to OFFB in
the menu ( 28).
• The remote sensor modes of the wireless
controller and the camcorder itself are different
( 28).
• The batteries are dead or not inserted.
• Check the screen displays ( 135).
• This is unlikely, but may happen if you use the
camcorder in places where the air pressure is
low, in an airplane for example. The bubbles will
disappear a week or so after you return the
camcorder to normal atmospheric pressure.
•External interference may cause the camcorder’s
microprocessor to malfunction temporarily. If
random letters appear in the display or if normal
operation is interrupted, remove and then
replace the power source.
• Remove the cable and then reconnect it or turn
the power off and back on again.
• This is not a malfunction.
Problem
? The wireless controller does not work.
? The power indicator is flashing.
? There are air bubbles inside the lens.
? The camcorder malfunctions.
? The DV cable is connected correctly, but
there’s nothing in the display.
? The camcorder becomes warm during
use.