Filter
Top Products
CHAPTER
3-1
Cisco Video Surveillance 5010/5011 Indoor Fixed HD IP Dome Camera User Guide
OL-22669-02
3
Operation
Camera Configuration Sequence
Once the camera is installed and power is applied, the camera will start a configuration sequence: the
green LED flashes five times per second for approximately two minutes and then glows solid green,
indicating that the boot cycle is complete and the camera is on line.
Note If the camera is not connected to a Dynamic Host Configuration Protocol (DHCP) server and DHCP is
enabled, the configuration sequence might take up to five minutes to complete.
Refer to the following topics for more information:
• Network Tab, page 3-9
• Turning On DHCP, page 3-10
• Turning Off DHCP, page 3-11
Minimum System Requirements
Network and processor bandwidth limitations might cause the video stream to pause or appear pixilated
when an increased number of Web interface users connect to the camera. Decrease the images per second
(ips), resolution, compression, or bit rate settings of the Web interface video streams to compensate for
network/processor limitations.
The following minimum system requirements are needed to use a Web browser with the IP camera:
• Processor: Intel
®
Core
™
2 Duo microprocessor, 2.6 GHz
• Operating system: Microsoft
®
Windows
®
XP
• Memory: 2 GB RAM
• Network interface card: 100 megabits (or greater)
• Monitor: Minimum of 1024 x 768 resolution, 16- or 32-bit pixel color resolution
• Web browser: Internet Explorer
®
8.0
• Media Player: QuickTime 7.6.5 for Windows XP