Filter
Top Products
1.
Check that the dust cover is tilted up to make it easier to see inside
the printer, as shown in Figure 1-9.
2. Make sure the paper release lever is pushed back in the direction of
the arrow in the figure, and that the paper bail is pulled away from
the platen.
Figure 1-9. Loading single-sheet paper
3. Insert a single sheet of paper behind the platen as shown in Figure
1-9. Put the left edge of the paper against the edge tab on the single
sheet guide.
4. With the power OFF use the paper feed knob to roll the paper into
the printer far enough to be held by the paper bail. (If the power is
ON, use the LINE FEED button as described in Step 6.)
5.
Push the paper bail back against the paper, and the paper is ready.
1-10