Filter
Top Products
4. Make sure the paper release lever is pushed back as shown in Fig-
ure
2-1.
If this lever is not pushed back, the cut sheet feeder will not
fit or operate properly.
5. Pull the paper bail away from the platen (the black roller) as shown
in Figure 2-1. The paper bail should remain in this position when-
ever the cut sheet feeder is installed.
6. Now locate the rear mounting pins on the LQ as shown in Figure
2-2. The rear notches on the cut sheet feeder unit rest on these
mounting pins.
Figure 2-2. Installing the cut sheet feeder
2-2