Filter
Top Products
Chapter 2
The Cut Sheet Feeder
The cut sheet feeder automatically loads single sheets of paper into
the LQ, allowing you to print on letterhead, bond, or individual
forms.
Installing the Cut Sheet Feeder
1. Make sure the power is OFF.
2.
Set DIP switch 1-8 on the back of the printer to the ON position
and DIP switch 1-7 to the OFF position to select the cut sheet
feeder. See Appendix A for information on resetting the DIP
switches.
3. Remove the front cover that came installed on your LQ by tilting it
up and lifting it off the printer. Replace it with the new cover
included with the cut sheet feeder, as shown in Figure
2-1.
Leave the
new cover in an upright position so you can see inside the printer.
Also remove the single-sheet guide.
Figure 2-1. Preparing the printer for installation
2-1