Filter
Top Products
7.
Hold the cut sheet feeder assembly in two hands, and press the two
cut sheet feeder release levers shown in Figure 2-1.
8. Now stand directly over the printer, look
through
the top of the cut
sheet feeder, and guide the rear notches on the cut sheet feeder onto
the rear mounting pins on the printer.
9. Tilt the cut sheet feeder forward until the front latches of the cut
sheet feeder engage the front mounting pins on the printer. Release
the levers and the cut sheet feeder locks in place.
Note
When the cut sheet feeder is properly installed, it
is
possible to
tilt it forward slightly, but you cannot remove it from the
printer without pressing the release levers. If you can remove
the cut sheet feeder by simply lifting it off the LQ, reread the
installation instructions, paying special attention to setting
the rear notches of the feeder on the rear mounting pins of the
printer.
10. With the cut sheet feeder in place, you can now install the three
brackets supplied with the unit. To install the two small brackets,
squeeze them together and insert them into the holes on top of the
paper supports, as shown in Figure 2-3.
Figure 2-3. Installing the small brackets
2-3