Filter
Top Products
61
Taking Pictures and Recording Video Clips
Using the Burst Setting
Burst allows you to take two or more pictures (depending on
available memory space) as quickly as possible when you
press and hold the Shutter button all the way down.
1. Press , use the buttons to highlight Burst ,
then press .
2. Frame the subject and press the Shutter button halfway
down to lock the focus and exposure. Then press the
Shutter button all the way down and hold it. The camera
takes pictures as quickly as possible until you release the
Shutter button or the camera runs out of memory.
The Image Display remains off during the burst capture. After
the burst images have been taken, each image appears one
at a time in Instant Review (see page 117). You can delete
the images during Instant Review by pressing , then
selecting Entire Burst Sequence in the Delete sub-menu.
The Burst setting remains in effect until it is changed again,
or until it resets to the default Timer Off setting when you turn
the camera off. To save changed settings, use My Mode (see
page 56).
NOTE: The Burst setting is not available while recording
video clips nor in Panorama or Document shooting
modes. You also cannot record audio when using the
Burst setting, but you can add an audio clip later (see
page 96). Also, the flash is not available while using the
Burst setting.
NOTE: If you have set Bracketing (see page 66) with Burst,
the camera captures a set of three images using the
settings you specified in Bracketing.