Filter
Top Products
SurePOS 100 Technical Reference
Page 100 of 104
A dialog which title is ‘Query/Download/Upload’ appears and presses ‘OK’ to start keyboard communication. You
can also Check Connection from menu ‘SystemÆCheck Connection’. If SurePOS100 Keyboard is detected, the
Download Current Configuration to the Keyboard hot key is enabled. See the above picture.
Setup properly configuration items from IBM SurePOS100 Keyboard Configuration Utility (AP).
Press Download Current Configuration to the Keyboard hot key or from menu ‘SystemÆDownload Configuration’
to download Utility current configuration to SurePOS100 Keyboard.
Code Update
Connect external keyboard to IBM SurePOS100 Keyboard by PS/2 or USB and open IBM SurePOS100 Keyboard
Configuration Utility (AP).
A dialog which title is ‘Query/Download/Upload’ appears and presses ‘OK’ to start keyboard communication. You
can also Check Connection from menu ‘SystemÆCheck Connection’. If SurePOS100 Keyboard is detected, the
menu ‘SystemÆCodeUpdate’ item is enabled.
To run the menu ‘SystemÆCodeUpdate’ item and input a FW file to run code update (renew firmware).
Configure MSR Track Headers and Trailers
Press the MSR Track Header and Trailer Programming Hot Key of the below picture or from menu ‘System-
>Configure MSR Track Headers and Trailers’ to enter MSR Configuration Panel.
To select configuration Track from the Track Selection Panel.
To configure each Track Header/Trailer from the Header and Terminator Setup Panel, press the Edit button to
edit Header/Trailer, or press Default button to load default Header/Trailer. Each Header/Trailer can store
maximum 20 chars.(The default Header/Trailer (H/T)for each Track is: T1(H): %, T1(T): ?+Enter, T2(H): ;, T2(T):
?+Enter, T3(H): ;, T3(T): ?+Enter)
This setting must combine with Configure MSR Characteristics setting. We will describe both relations in the
Configure MSR Characteristics setting.
Configure MSR Characteristics
From menu ‘System->Configure MSR Characteristics’ to enter MSR Characteristics Configuration Panel.
To set each Track Configuration from the Track-X Configuration Panel. The setting meaning are as below:
2.1. Sentinels Enable/Disable: To let Track Header and Trailer visible/invisible.
2.2. Programmable Sentinels Enable: To let Track Header and Trailer display as we defined in
Configure MSR Track Headers and Trailers
2.3. Programmable Sentinels Disable: To let Track Header and Trailer display use default value.
The default Header/Trailer (H/T) for each Track is:
T1(H): %, T1(T): ?+Enter, T2(H): ;, T2(T): ?+Enter, T3(H): ;, T3(T): ?+Enter
2.4. Carriage Return Enable/Disable: To let each Track Carriage Return (Enter) visible/invisible.
This setting is valid while Programmable Sentinels is disabled.
To configure each Track visible/invisible property from the Individually Selectable Panel.
To configure each Track swipe card data display speed from the Data Speed Selectable Panel.
Configure MSR Translation
From menu ‘System->Configure MSR Translation’ to enter MSR Translation Configuration Panel.
To select a MSR Translation mode from the MSR Translation mode Configuration Panel.
To set MSR Track display value from the Track1 Configuration Panel and Track 2 & 3 Configuration Panel. This
setting is valid while the MSR Translation mode is User Defined.
Press Apply button to let setting take effect.
Configure Prefix and Keyboard
Data identification will take place via a set of special keycodes in front of and behind the datastream from the
particular device, for example:
<data id character> <device datastream> <data id character>