Filter
Top Products
SurePOS 100 Technical Reference
Page 58 of 104
9.3.11.3 Start Codes Format
Code Format
START A %6 25H 36H *
START B %7 25H 37H *
START C %8 25H 38H *
* = For CODE 128 only
Function:
Full-cut command to the auto-cutter
Code:
"d" "0" or "d"
Outline:
Cuts the paper partially when memory switch #2, bit C is set to 0. If memory switch #2, bit C is set to 1, the paper
is fed 18 mm (0.7 in.) and then cut fully. When the auto-cutter is invalid (set by memory switch #2, bit 8), this
command is ignored.
Function:
Partial-cut command to the auto-cutter
Code:
"d" "1" or "d"
Outline:
Cuts the paper partially when memory switch #2, bit C is set to 0. If memory switch #2, bit C is set to 1, the paper
is fed 18 mm (0.7 in.) and then cut partially. When the auto-cutter is invalid (set by memory switch #2, bit 8), this
command is ignored.
Function:
Set memory switch
Code:
"#N,n1n2n3n4"
1Bh 23h N 2Ch n1n2n3n4 0Ah 00h
Outline:
Set the memory switch. The memory switch is a "soft" dip switch to set the printer configuration. After the memory
switch command has been sent, the setting can be enabled by setting the printer OFF and ON again or sending
the printer reset command "?" to the printer. Changed memory switch settings are stored in EEPROM and these
settings will be stored permanently on the printer logic circuit board.
Table 3-6. Default Memory Switch Settings (n1n2n3n4)
N Standard Japanese Korean Simplified
Chinese
Traditional
Chinese
0 0000 0010 0010 0010 0010
1 0100 0100 0100 0100 0100
2 0100 0100 0100 0100 0100
3 0300 0000 0000 0010 0010
4 0000 0000 0000 0000 0000
E 0000 0000 0000 0000 0000
Note: Memory switch "D" is not shown because it does not have a default setting.
To set the memory switches for the Standard, Traditional Chinese, or Simplified Chinese versions to
match the Star TSP200 series printer, send the following commands to the printer:
"#3,0000"
"?"