Filter
Top Products
KRAMER: SIMPLE CREATIVE TECHNOLOGY
Operating Your SDI Video Matrix Switcher
22
2. Press the appropriate IN button.
The MATRIX Display shows the 2 blinking digits, representing the input
number and the TAKE LED blinks.
The STATUS Display shows
1
the message:
out # x
from in # y
Where x is the output number and y is the input number
3. Press the second appropriate OUT button, repeating step 1 above.
4. Press the appropriate
2
IN button, repeating step 2 above.
5. Continue with this OUT-IN button sequence, pressing the appropriate OUT
and IN buttons, as required. You can also combine an OUT-OFF or OFF-
OUT combination with this sequence.
6. After completing the sequence, press the TAKE button to confirm the
actions.
The inputs switch to the respective outputs, as the MATRIX Display shows
(no digits blink) and the TAKE LED lights.
7.2.2.3 Switching One Input to All Outputs
To switch one input to all the outputs (in the AT ONCE mode):
1. Press the ALL button.
The MATRIX Display shows all the sets of 2 blinking digits (each
representing the present input number for that respective output) blinking
simultaneously.
The STATUS Display shows the message:
all OUTs
2. Press the appropriate IN button.
This input switches to all the outputs and the MATRIX Display shows the
identical non-blinking 2 digits (representing that input number).
To switch one input to all the outputs (in the CONFIRM mode, (the TAKE
LED is lit)):
1. Repeat steps 1 and 2 above.
The TAKE LED blinks.
2. Press the TAKE button to confirm the action.
The selected input switches to all the outputs and the TAKE LED lights.
1 Continuously, within the limit of the timeout (approximately 30 seconds)
2 That corresponds with the second OUT button