Filter
Top Products
Using the MENU Command Sequence
31
2. Press the TAKE button.
The Displays show the messages:
set UNIT follow SYSTEM?
Press TAKE to execute
current:
breakaway
3. Press the TAKE button again.
The MATRIX Display momentarily shows this message, followed by the
status of the switcher and in the STATUS Display the letter “S” is
displayed behind the blinking cursor:
the UNIT is set in mode
FOLLOW system
If the status of the VS-1616SDI unit differs from that of the other unit(s), set
the VS-1616SDI unit to the Follow-SYSTEM mode. The MATRIX Display
blinks the new status of the switcher and the TAKE LED blinks. Pressing
the TAKE button
1
implements all the changes to the same state as the rest of
the system placing the switcher in the Follow-SYSTEM mode.
To set the VS-1616SDI unit to function in the Breakaway-from-SYSTEM
mode:
1. Press the MENU button twice.
The MATRIX Display shows the message:
FOLLOW the system
yes -> TAKE, next -> MENU
2. Press the TAKE button.
The Displays show the messages:
BREAKAWAY from system?
Press TAKE to execute
current:
follow SYS
3. Press the TAKE button again.
The MATRIX Display shows the message:
the UNIT is set in mode
BREAKAWAY from system
8.3 Choosing the SWITCHING METHOD Setting
Section 8.3.1 describes the SWITCHING METHOD settings for stand alone
units and large matrices. Section 8.3.2 describes how to configure a
SWITCHING METHOD.
1 Pressing a different button cancels the operation and the switcher will remain in its previous state