Mackie HDR 24/96 Camcorder User Manual


 
22
HDR 24/96
HDR 24/96
TDIF Hookup (DIO•8)
NoteNote
NoteNote
Note: Determining
which unit in
Figure 1
provides the master
clock depends on
your application. For
information on ad-
vanced applications,
see the Applications
Manual.
Cables & Hardware
(3) DIO8 cards for HDR24/96
(3) DIO8 cards for D8B
(1) Clock I/O card for D8B
(3) TDIF cables
(1) 75 BNC word clock cable
Hookup
1. Connect the three TDIF cables between the corresponding TDIF jacks on
the HDR24/96 and D8B.
2. When TDIF is used, the D8B must have a Clock I/O card installed. To
make the D8B the clock master, connect its Word Clock Out (not DIO8
Sync out) to the HDR24/96 Word Clock In. To make the HDR24/96 the
clock master, connect its Word Clock Out to the D8B Word Clock In.
See Figure 1.
HDR24/96 Settings
1. Set the Tape Input format for each DIO8 card to TDIF, and the Tape
Output format to TDIF.
2. If the HDR24/96 is the clock master, set the Sample Clock to Internal;
if it is a clock slave, set it to Word Clock and depress the 75
termination switch on the Sync card.
3. Set the Sample Rate to 44.1 kHz or 48 kHz according to your
preference.
Console Settings
1. Set the Tape Input and Tape Output format for each DIO8 card to TDIF.
2. If the D8B is the clock master, set the Sample Clock to either 44.1 k
Internal or 48 k Internal; if it is a clock slave, set the Sample Clock to
either 44.1 kHz or 48 kHz. Set the Sample Rate to match the Sample
Rate selected on the HDR24/96.