Mackie HDR 24/96 Camcorder User Manual


 
9
Quick Start Guide
Quick Start Guide
To install the I/O cards:
1. If the HDR24/96 is plugged into AC power, unplug it.
2. Remove the I/O card slot cover plates by removing the rather tight top
and bottom screws with a screwdriver.
3. Before you take I/O cards from their bags, touch a grounded metal object
to discharge any static electricity from your body.
4. Remove the I/O card from its bag and hold it so that the component side
faces left.
5. Line up the card so that the top and bottom
edges slide smoothly into the white card
guides. Push the card all the way in until its
faceplate is flush with the back panel.
6. Hand-tighten the thumbscrews at the top
and bottom of the card. Do not use a
screwdriver.
Note:Note:
Note:Note:
Note: Always hand tighten the thumbscrews
at the top and bottom of all I/O cards be-
fore operating the HDR 24/96.
If you want to hook up the HDR24/96 I/O cables
to your console right now, see the console hookup
diagrams in Hookups (page 20). Be sure to come
right back here when you’re done.