Filter
Top Products
90
t
Exposure Compensation
Exposure compensation is used to alter exposure from the value suggested by the
camera, making pictures brighter or darker.
It is most effective when used with
center-weighted or spot metering (
pg.
87).
Exposure compensation is available in modes P, S, and A (in mode M, only the
exposure information shown in the electronic analog exposure display is affected;
shutter speed and aperture do not change).
Press the E button and rotate the main
command dial until the desired value is
displayed in the control panel.
Exposure
compensation can be set to values
between –5 EV (underexposure) and
+5 EV (overexposure) in increments of
1
/3 EV.
In general, choose positive values
to make the subject brighter, negative
values to make it darker.
At values other than ±0, a E icon will be displayed in the control panel and
viewfinder after you release the E button.
The current value for exposure
compensation will be displayed when the E button is pressed.
Normal exposure can be restored by setting exposure compensation to ±0.
Exposure
compensation is not reset when the camera is turned off.
A
See Also
For information on choosing the size of the increments available for exposure compensation,
see Custom Setting b1 (EV steps for exposure cntrl., pg. 177).
For information on making
adjustments to exposure compensation without pressing the E button, see Custom Setting b2
(Easy exposure compensation, pg. 177).
E button
Main command dial
±0 EV
(E button pressed)
–0.3 EV
+2 EV
–1 EV No exposure
compensation
+1 EV