Filter
Top Products
29
X
Inserting Memory Cards
The camera stores pictures on Secure Digital (SD) memory cards (available
separately).
1 Turn the camera off.
Always turn the camera off before inserting or
removing memory cards.
2 Open the card slot cover.
Slide the card slot cover out (q) and open the card slot
(w).
3 Insert the memory card.
Holding the memory card as shown at right, slide it in
until it clicks into place.
The memory card access lamp will
light for a few seconds.
Close the memory card slot cover.
D
Inserting Memory Cards
Inserting memory cards upside down or backwards could
damage the camera or the card.
Check to be sure the card is in
the correct orientation.
If C is displayed in the control panel as shown at right,
format the card as described on the following page.
D
The Access Lamp
Do not remove the battery or disconnect the power source while the memory card access
lamp is lit.
Failure to observe this precaution could result in damage to the card.
Power switch
Front
Access lamp