Filter
Top Products
102
VQT0X39
Troubleshooting
Problem Check points
This unit cannot be
turned on.
≥ Is the battery fully charged?
>Charge the battery using the AC adaptor. (P18)
This unit is turned off
automatically.
≥ If you do not use the unit for approximately 5 minutes,
the power is automatically turned off to conserve the
battery charge. (P95) To resume recording, turn the
power back on.
The power will not turn off automatically when the
power save function (P95) is set to [OFF].
This unit does not stay
on long enough.
≥ Is the battery low?
>If the remaining battery power indication is flashing or the
message “LOW BATTERY.” is displayed, the battery has
run down. Charge the battery. (P18)
Battery runs down
quickly.
≥ Is the battery fully charged?
>Charge it with the AC adaptor. (P18)
≥ Are you using the battery in an extremely cold place?
>The battery is affected by ambient temperature. In cold
places, the operating time of the battery becomes
shorter.
≥ Has the battery worn out?
>The battery has a limited life. If the operating time is still
too short even after the battery is fully charged,
depending on the usage, the battery has worn out and
can no longer be used.
This unit cannot be
operated though
powered up.
This unit does not
operate normally.
≥ This unit cannot be operated unless you open the LCD
monitor.
≥ Press the [RESET] button. (P105) If normal conditions
are not restored yet, remove the battery or disconnect
the AC adaptor, wait about 1 minute and then reinsert
the battery or reconnect the AC adaptor. Then, about
1 minute later, turn on the power again. (Conducting the
above operation when the access lamp is on may
destroy the data on the SD card.)
The remote control does
not function.
≥ Has the button-type battery of the remote control run
out?
>Replace it with a new button-type battery. (P13)
The screen has changed
suddenly.
≥ Has the demonstration started?
>If you set [DEMO MODE] to [ON] without inserting an SD
card in motion picture recording mode or still picture
recording mode, the unit is automatically set to the
demonstration mode for introducing its functions.
Normally this should be set to [OFF]. (P95)
VQT0X39ENG.book 102 ページ ２００６年６月１４日 水曜日 午前１０時５１分