Filter
Top Products
111
VQT0X39
≥ The battery may have excessively
discharged. It can be recharged but in
some cases it may take several hours
until regular charging commences.
When the status indicator flashes at
intervals of about 0.5 second (on for
about 0.25 sec. and off for about
0.25 sec.):
≥ The battery has not been recharged.
Remove the battery from the unit, and
try charging it again.
≥ The battery temperature or ambient
temperature may be extremely high or
low. Wait until the appropriate
temperature is restored before
charging the battery again. If the
battery still fails to charge, something
may be wrong with the unit, battery, AC
adaptor etc. Contact your dealer.
When the status indicator is off:
≥ Charging is completed.
≥ Although charging is not completed,
trouble may have occurred in the AC
adaptor or battery when the status
indicator is off. Contact your dealer.
≥ The memory capacity
indicated on the label of an
SD Card is the total of the
capacity for copyright
protection and
management and the
capacity which can be used on the
unit, a PC etc.
≥ During prolonged use, the unit’s
surfaces and the SD card will heat up
slightly: This is normal.
When inserting or removing the SD
card, always set the [ON/OFF] switch
to [OFF].
When the access lamp is illuminated
(During access to the SD card), do not
open the card slot cover to pull out the
SD card, rotate the mode dial, turn off
the power, or cause any vibrations or
impacts.
Do not leave the SD card in places
where there is high temperature or
direct sunlight, or where
electromagnetic waves or static
electricity are easily generated.
Moreover, do not fold or drop the SD
card, and do not strongly vibrate it.
≥ The SD card may break or the
contents of the card may be destroyed
or erased.
After use, be sure to eject the SD card,
and store it away.
≥ After use, or when storing or carrying
the SD card, put it in the storage case.
≥ Do not allow dust, water, or foreign
substances to adhere to the terminals
on the back of the SD card. Moreover,
do not touch the terminals with your
hand.
≥ Keep the SD Memory Card out of
reach of children to prevent
swallowing.
≥ When the LCD monitor gets dirty, wipe
it with a dry soft cloth.
≥ In a place with drastic temperature
changes, condensation may form on
the LCD monitor. Wipe it with soft dry
cloth.
≥ When the unit has become very cold,
for example due to storage in a cold
area, its LCD monitor will be slightly
darker than usual immediately after the
power is turned on. The normal
brightness will be restored when the
unit’s internal temperature rises.
About the SD card
2
LCD monitor
Extremely high precision technology is
employed to produce the LCD Monitor
screen featuring a total of
approximately 210,000 pixels. The
result is more than 99.99% effective
pixels with a mere 0.01% of the pixels
inactive or always lit. However, this is
not a malfunction and does not affect
the recorded picture.
VQT0X39ENG.book 111 ページ ２００６年６月１４日 水曜日 午前１０時５１分