Filter
Top Products
103
VQT0X39
Problem Check points
Recording does not
start although power is
supplied to this unit and
the SD card is correctly
inserted.
≥ Has the SD card’s write protect switch been set to
[LOCK]?
>No recording is possible while the write protect switch is
set to [LOCK]. (P16)
≥ Is the SD card’s memory full?
>If the card has no more available memory, free up some
memory by copying some scenes to a PC (P83) and then
deleting unnecessary scenes. (P65)
≥ Is the unit set to the motion picture recording mode or
still picture recording mode?
>No recording is possible unless the mode dial is at
or . (P21)
≥ Is the card slot cover open?
>If the card slot cover is open, this unit may not operate
normally. Close the card slot cover. (P15)
Motion picture
recording stops
suddenly.
≥ Can the SD card be used for motion picture recording?
>Use an SD card that can be used for motion picture
recording. (P35, 36)
Auto focus function
does not work.
≥ Is manual focus mode selected?
>If auto mode is selected, focus is automatically adjusted.
(P33)
≥ Are you trying to record a scene which is hard to bring
into focus in auto focus mode?
>There are some recording subjects and surroundings for
which the auto focus does not operate correctly. (P108) If
so, use the manual focus mode to adjust the focus. (P48)
≥ Is the MagicPix set?
>When the MagicPix is working, focusing shifts into the
manual mode. (P45)
A sentence is displayed
in the screen center.
≥ Read the contents and respond to them. (P98)
A function indication
such as mode
indication, remaining
time indication, or time
code indication is not
shown.
≥ If you set [SETUP]>[DISPLAY]>[OFF], indications
other than warnings and date indications disappear.
Sound is not played
back from the built-in
speaker of this unit.
≥ Is the volume too low?
>During playback, move the volume lever to display the
volume indication and adjust it. (P61)
VQT0X39ENG.book 103 ページ ２００６年６月１４日 水曜日 午前１０時５１分