Filter
Top Products
83
VQT0X39
After the driver and software applications are installed, the unit must be connected to the PC
and be correctly recognized by the PC.
≥ Connect after installing the driver and software applications.
If you connect this unit to a PC before installation, this unit may not be properly recognized.
≥ If a CD-ROM is inserted in the PC, remove it. (If the CD launcher is running, wait until it
finishes, then remove the CD-ROM.)
≥ If the recognition procedure is not accomplished properly, operation will not be possible
after connecting the unit to the PC.
≥ If the unit fails to operate normally, it may mean that you have not conducted the
installation or recognition procedure properly.
≥ Use AC adaptors as the power supply for the unit and the equipment connected to it.
¬ Connect this unit to the AC adaptor.
1 Select this unit’s operation mode.
≥ When this unit is in still picture playback mode, connect it to a printer supporting
PictBridge. (P70)
2 Open this unit’s terminal cover, then
firmly plug one end of the USB cable
1 (supplied) into the USB terminal
and the other end into the terminal on
the PC.
≥ Insert the plugs as far as they will go. The unit
and PC will not operate properly if they are not
inserted fully.
≥ Do not use any other USB cables except the
supplied one. (Operation is not guaranteed
with any other USB cables.)
≥ When the unit is set to PC Connection mode and connected to a PC, the
operation mode cannot be changed and its power cannot be turned off.
In this case, disconnect the USB cable (P89), change the operation mode and then
turn off its power.
Connection and recognition procedures