Filter
Top Products
Connecting to other equipment
101
VQT0W82
1 Turn on the camera and the
printer.
2 Connect the camera to a printer
via the USB connection cable
(supplied).
• Align the [1] mark on the USB
connection cable and the [ ] mark
on the terminal of the adaptor when
connecting.
• Hold the USB connection cable at C
and insert straight in or take straight
out.
3 Press 4 to select
[PictBridge (PTP)] and then press
[MENU/SET].
• If you set [USB MODE] in the [SETUP]
menu to [PictBridge (PTP)] in advance,
it is not necessary to set this every time
you connect to a Printer. (P29)
• Do not use any other USB connection
cables except the supplied one.
∫ Single picture
1 Press 3 to select
[SINGLE PICTURE] and then
press [MENU/SET].
2 Press 2/1 to select the picture
and then press 4.
• The message disappears in about
2 seconds.
3 Press 3 to select [PRINT START]
and then press [MENU/SET].
• Press [MENU/SET] to cancel printing.
4 Disconnect the USB connection
cable after printing.
USB MODE
SELECT SET
MENU
PC
PLEASE SELECT
THE USB MODE
PictBridge(PTP)
SET
MENU
SET
MENU
PictBridge
SET
SELECT
SINGLE PICTURE
MENU
DPOF PICTURE
PLEASE SELECT
THE PICTURE TO PRINT
PictBridge
SELECT
EXIT
MENU
PRINT
1/19
100
-
0001
SET
MENU
CANCEL SELECT SET
MENU
PRINT START
PRINT WITH DATE
NUM. OF PRINTS
PAPER SIZE
PAGE LAYOUT
SINGLE PICTURE
1