Filter
Top Products
Preparation
17
VQT0W82
3 Detach the lens cap.
∫ Optical image stabilizer
The supplied lens has an optical image
stabilizer function.
The optical image stabilizer function is set
for activation when the lens is attached to
the camera body.
Set the [O.I.S.] switch to [ON].
• You can change the optical image
stabilizer mode to [MODE1] or [MODE2]
using [OIS MODE] in the [REC] mode
menu (P82). It is set to [MODE1] at the
time of purchase.
• We recommend setting the [O.I.S.] switch
to [OFF] when using a tripod. If the [O.I.S.]
switch is set to [OFF], [ ] is displayed
on the LCD monitor.
∫ Detaching a lens from the camera
body
• Check that the camera is turned off.
1 Attach the lens cap.
2 Set the [O.I.S.] switch to [OFF].
3 Press the lens release button D
while turning the lens as far as
possible in the direction of the
arrow to detach it.
• Always attach the body cap to the
camera body so that dirt or dust does
not get inside.
• Attach the lens rear cap so that the lens
contact point does not get scratched.
• Change lenses where there is not a lot of
dirt or dust.
• When you turn the camera off or carry the
camera, attach the lens cap to protect the
surface of the lens.
• Detach the lens cap before taking
pictures.
• Be careful not to lose the lens cap, the
lens rear cap and the body cap.
OFF ON
D