Filter
Top Products
Advanced
61
VQT0W82
• When you take a picture beyond the
available flash range, the exposure may
not be adjusted properly and the picture
may become bright or dark.
• The white balance may not be properly
adjusted if the flash level is insufficient.
(P68)
• If you repeat taking a picture, it may not
actually be taken even if the flash is
activated. Take a picture after the access
indication disappears.
• The red-eye reduction effect differs
between people. Also, if the subject was
far away from the camera or was not
looking at the first flash, the effect may not
be evident.
• When the flash is being charged, the flash
icon blinks red, and you cannot take a
picture even when you press the shutter
button fully.
• When taking pictures in burst mode or
auto bracket, only 1 picture is recorded for
every flash activated.
• If you take pictures with the flash when
the lens hood is attached, the flash
may be obscured by the lens hood.
• When you attach an external flash, it takes
priority over the built-in flash. Refer to
P105 for the external flash.
Adjust the flash output when the subject is
small or reflection ratio is extremely high or
low.
1 Press [ ] A.
B: When taking pictures with Live view
2 Rotate the command dial C to
adjust the flash output.
D: When taking pictures with Live view
• Rotate the command dial upwards to
adjust towards negative and rotate the
command dial downwards to adjust
towards positive.
• You can adjust from [`2EV] to [_2EV]
in steps of [1/3 EV].
• Select [0] to return to the original flash
output.
• The flash output adjustment value E is
displayed on the LCD monitor when
taking pictures with Live View.
Adjusting the flash output
STANDARD
STANDARD
ISO
ISO
100
100
AUTO
AUTO
WB
WB
19
19
SINGLE
SINGLE
NORMAL
NORMAL
CUSTOM
CUSTOM
-
1 +1
+1
0
-
2 +2
+2
P
B
A
STANDARD
STANDARD
ISO
ISO
100
100
AUTO
AUTO
WB
WB
19
19
SINGLE
SINGLE
NORMAL
NORMAL
CUSTOM
CUSTOM
-
1 +1
+1
0
-
2 +2
+2
P
C
D