Filter
Top Products
RealPresence Collaboration Server (RMX) 1500/1800/2000/4000 Administrator’s Guide
Polycom®, Inc. 748
BONDING_CHANNEL_DELAY
(ISDN)
Applicable to the RealPresence Collaboration Server
(RMX) 1500/2000/4000 only.
When connecting a bonding group, this is the delay (number of 1/100
seconds) between dialing attempts to connect sequential channels.
The channel per second connection performance of ISDN switches
can vary and can cause timing issues that result in bonding channel
disconnection.
Default: 6
CHANGE_AD_HOC_CONF_
DURATION
The duration of an ad-hoc conference* can be configured on a system
level by setting the flag to one of the following values (in minutes): 60
(default), 90, 180 and 270.
* An ad-hoc conference is automatically created when the participant
dials into an Ad-hoc Entry Queue and enters a conference ID that is
not being used by any other conferencing entity. It is based on the
Conference Profile assigned to the EQ.
CHECK_ARPING This flag is not supported from Version 7.7.
Disables Duplicate Address Detection and should be configured
according to local site policy. When set to YES, Duplicate Address
Detection is enabled in for both IPv4 and IPv6. When set to NO,
Duplicate Address Detection is disabled for both IPv4 and IPv6. When
using IPv6, ICMPv6 type 135 packets are also disabled.
CONTENT_SLAVE_LINKS_INTR
A_SUPPRESSION_IN_
SECONDS
Defines the interval, in seconds, during which the Collaboration Server
is allowed to forward an Intra Request received from any of the Slave
Cascading Links. The Slave Cascading Link can be connected to the
local Collaboration Server, to an MCU on a higher cascade level or to
the Content sharer.
The first Intra request that is received from any of the Slave MCUs
connected to the Collaboration Server starts the interval counter and is
forwarded to the next level MCU or to the Content sharer.
All other Intra requests that are received within this interval are
registered but ignored. After an interval of <flag value> seconds, the
system checks if during the last interval any additional Intra requests
were registered. If there is at least one Intra request it will be
forwarded. If there is no additional Intra request not no action is taken
other than to wait for the next cycle.
This filtering process is repeated every <flag value> seconds.
Default: 30
CONTENT_SPEAKER_INTRA_S
UPPRESSION_IN_SECONDS
This flag controls the requests to refresh (intra) the content sent from
the Collaboration Server system to the content sender as a result of
refresh requests initiated by other conference participants.
Enter the interval in seconds between the Intra requests sent from the
Collaboration Server to the endpoint sending the content to refresh the
content display. Refresh requests that will be received from endpoints
within the defined interval will be postponed to the next interval.
Default setting: 5
Flag Description