Polycom 4000 Security Camera User Manual


  Open as PDF
of 1183
 
RealPresence Collaboration Server (RMX) 1500/1800/2000/4000 Administrator’s Guide
Polycom®, Inc. 765
ACCEPT_VOIP_DTMF_TYPE Defines the type of DTMF tones (inband) or digits (outband) that the
Collaboration Server will accept in VOIP calls.
Range:
0 - Auto (default):
Inband or outband DTMF tones/digits are accepted depending on
the endpoint's current setting. If the endpoint switches from inband
to outband or visa versa the value of the
SET_DTMF_SOURCE_DIFF_IN_SEC flag determines the time
interval after which both inband and outband tones/digits will be
accepted.
•1 - Outband (H.245) only
•2 - Inband only
ALLOW_NON_ENCRYPT_PART
Y_IN_ENCRYPT_CONF
If YES, allows non-encrypted participants to connect to encrypted
conferences.
Default: No
Note: From Version 7.6.1, this flag is replaced by the Encryption option
“Encrypt when Possible” in the conference Profile - Advanced dialog
box. Flag setting is ignored.
ALWAYS_FORWARD_DTMF_IN_
GW_SESSION_TO_ISDN
(ISDN)
Applicable to the RealPresence Collaboration Server
(RMX) 1500/2000/4000 only.
When set to YES, all DTMF codes sent by participants in the GW
session will be forwarded to all PSTN and ISDN participants in the
same GW session.
Range: YES / NO
Default Value: NO
ANAT_IP_PROTOCOL If YES, enables Alternative Network Address Types. For more
information, see Alternative Network Address Types (ANAT).
Range: DISABLED, AUTO, PREFER_IPv4, PREFER_IPv6
Default:
ULTRA SECURE MODE: NO
STANDARD SECURITY MODE: YES
APACHE_KEEP_ALIVE_TIMEOU
T
If the connection is idle for longer than the number of seconds specified
by this flag, the connection to the Collaboration Server is terminated.
Value: 0 - 999
Default: 15
Default (ULTRA_SECURE_MODE=YES): 15
Note: A value of 0 results in an unlimited keep-alive duration. This
value should never be used in Ultra Secure Mode.
AVOID_VIDEO_LOOP_BACK_IN
_CASCADE
When set to YES the current speaker’s image is not sent back through
the participant link in cascaded conferences with conference layouts
other than 1x1.
Default: YES
Range: YES / NO
Manually Added, Modified, Deleted System Flags
Flag Description