Filter
Top Products
ReplayTV 4500
If your satellite receiver uses a 15-pin serial cable, you will need to use the 9-pin to 15-pin adapter to connect
the satellite receiver to ReplayTV.
If you have a satellite receiver that uses telephone cable in place of serial cable, you will need to use the
RJH to 9-pin adapter to connect the satellite receiver to ReplayTV. RCA models DRD221RD, DRD222RD,
DRD223RD, and DS2122RD will all require this adapter.
The Ethernet cable connects to the ETHERNET jack on ReplayTV, allowing you to connect ReplayTV to a
broadband network. If you have a home network, you should leave ReplayTV connected to it at all times,
because ReplayTV will use it to receive Channel Guide listings.
The telephone cable connects from the TEL LINE jack on ReplayTV to awall jack. Leave the cable connected
to ReplayTV at all times to receive the daily Channel Guide listings.
A VGA cable (not included) delivers the best picture quality, if supported by your television or monitor.
ReplayTV currently supports RGB (VGA) and YPbPr (component) progressive video formats. If your televi-
sion or monitor has a VGA input connector, use a standard VGA cable.
Macrovision protected programming will be recorded if you use the YPbPr video setting but cannot be viewed
using this setting. You must change the video setting to “RGB” or “None” to view Macrovision protected pro-
gramming. Select Video Output Settings from the Setup screen to change the setting.