Filter
Top Products
1 This equipment complies with FCC Rules, Part 68. On this equipment is a label which contains, among other information, the
FCC Part 68 registration number.
2 The Federal Communications Commission (FCC) has established Rules which permit this device to be directly connected to
the telephone network. Standardized jacks are used for these connections. This equipment should not be used on party lines or
coin phones.
3 If this device is malfunctioning, it may also be causing harm to the telephone network; this device should be disconnected until
the source of the problem can be determined and until repair has been made. If this is not done, the telephone company may
temporarily disconnect service. All repairs should be performed by SONICblue, Inc. or an authorized agent. It is the responsi-
bility of users requiring service to report the need for service to SONICblue, Inc. or to one of our authorized agents. Service can
be facilitated through SONICblue Customer Care.
4 The telephone company may make changes in its technical operation and procedures; if such changes affect the compatibility
or use of this device, the telephone company is required to give adequate notice of the changes. You will be advised of your
right to file a complaint with the FCC.
5 If the telephone company requests information on what equipment is connected to their lines, inform them of:
a. The telephone number to which this unit is connected.
b. The ringer equivalence number: REN: 0.01B
c. The USOC jack required: RJ11C.
d. The FCC Registration Number: MKAUSA-42040-DT-T
Items (b) and (d) are indicated on the label. The Ringer Equivalence Number (REN) is used to determine how many devices can be
connected to your telephone line. In most areas, the sum of the REN’s of all devices on any one line should not exceed five (5.0). If
too many devices are attached, they may not ring properly.