Filter
Top Products
Chapter 4 Viewfinder Screen Indications and Menus 81
Chapter 4 Viewfinder Screen Indications and Menus
Basic menu page 2
Basic menu page 3
This is displayed when the SETUP switch has been set
to FILE.
For details of this operation, see “Setup Files” (page 94).
Basic menu page 4
This is displayed when the optional DSBK-501/501P
Analog Composite Input Board is fitted to the
camcorder.
If you set VIDEO IN to EXT and input the external VBS
signal from the GEN LOCK IN connector, the image in
the viewfinder and the signal output from the
MONITOR OUT connector are switched to the external
video signal. When inputting the external video signal,
“EXT INPUT” always blinks on the screen.
Notes
• When VIDEO IN is set to EXT, the video signals are
not output from the S VIDEO OUT connector.
• When VIDEO IN is set to EXT, the basic menu page
5 is not displayed.
Basic menu page 5
This menu is displayed when CAM is selected on the
basic menu page 4 and an external sync signal is input
to the GEN LOCK IN connector.
a) This applies when using an external sync signal to
synchronize operation of several camcorders (see page 44).
Item Settings
SKIN DTL
Sets the amount of
skin detail
correction.
0.0 to 0.5 (normal value) to 1.0
Smaller values set a softer skin detail.
LOW, STD (normal value), HIGH
Set the amount of DynaLatitude
effects as high level, standard level
(STD), or low level.
DL LEV
Sets the
DynaLatitude level.
m
SKIN DTL: OFF
DL LEV : STD
PRE WHT : 3200
Item Settings
VIDEO
IN
Selects
the
signal
to be
recorded
onto the
internal
VCR.
CAM (normal value)
Records the signal shot by this camcorder.
EXT
Records the signal input from the GEN LOCK IN/
VIDEO IN connector. The image on the
viewfinder and the signal output from the
MONITOR OUT connector are switched to the
external video signal. When inputting the external
video signal, “EXT INPUT” blinks on the screen.
m
SC PHASE: 000
H PHASE: 135
FILE:*FL
m
SELECT FILE
HISAT
CHG FILE
(YES
m
PUSH)
Item Settings
SC PHASE
Sub carrier phase adjustment for
when the camcorder is genlocked.
a)
000 to 999
H PHASE
Horizontal phase adjustment for
when the camcorder is genlocked.
a)
000 to 135 (normal value)
to 199
EXT INPUT
m
VIDEO IN: CAM
PRE WHT
Sets the color
temperature of the
preset white
balance.
When the filter is 3200 or CROSS:
2200 to 3200 (normal value) to 4300,
filter 5600K, 5600K + 1/8ND
When the filter is 5600K + 1/64ND:
4600 to 5600 (normal value) to 12000