Sony 500WSPL Camcorder User Manual


  Open as PDF
of 144
 
Chapter 4 Viewfinder Screen Indications and Menus 99
Chapter 4 Viewfinder Screen Indications and Menus
Using SetupNavi and SetupLog
The SetupNavi function records a setting of the setup
menu and setup files onto a tape, so that the same
settings can be called up and used again or copied to
another camera.
The SetupLog function records a camera setting every
few seconds at shooting and displays the recorded data
in the viewfinder during playback.
Note on using an RCP-TX7/RM-M7G Remote Control
Unit
When an RCP-TX7/RM-M7G is connected to the
camcorder, you can use neither the SetupNavi function
nor the SetupLog function.
To make it possible to use these functions, power OFF
the camcorder after disconnecting the RCP-TX7/RM-
M7G, then power ON the camcorder again.
Setting Up the Camera Using
Data Recorded on Tape
The procedure to replace camera’s menu settings with
settings recorded onto video tape is described here.
1 Insert the cassette onto which the data was
recorded. Set the SETUP switch to FILE, then set
the POWER switch to ON while holding down the
MENU dial.
Advanced menu page 1 appears.
2 Turn the MENU dial until advanced menu page 14
appears.
For details of menu operation, see “Advanced Menu
Operations” (page 86).
”NO TAPE” is displayed if you neglected to load a
cassette.
3 Move the cursor to RECALL DATA with the
MENU switch to call up the data recorded on the
tape. (Press the MENU switch to cancel.)
The tape is rewound and playback starts. The
display changes as follows and the call up
operation begins.
To abort the call up operation while in progress
Press the MENU dial.
After the data has been read, the following display
appears.
4 Press the MENU dial.
The previous menu settings are overwritten by the
data recorded on the tape.
5 Change the menu settings if necessary.
m
PAGE14(NEXT
m
$
PREV
m
4
)
SETUP NAVI
TAPE
m
CAMERA
RECALL DATA
(YES
m
PUSH)
EXIT MENU (YES
m
PUSH)
PLAY
PAGE14(NEXT
m
$
PREV
m
4
)
SETUP NAVI
TAPE
m
CAMERA
m
CANCEL TO RECALL
(YES
m
PUSH)
SETUP NAVI
ABCDEFGHIJ
EXIT MENU (YES
m
PUSH)
PAGE14(NEXT
m
$
PREV
m
4
)
SETUP NAVI
TAPE
m
CAMERA
m
SURE TO RECALL
(YES
m
PUSH)
EXIT MENU (YES
m
PUSH)
PAGE14(NEXT
m
$
PREV
m
4
)
SETUP NAVI
TAPE
m
CAMERA
m
DONE
EXIT MENU (YES
m
PUSH)
m
PAGE1 (NEXT
m
$
PREV
m
4
)
ALL RESET
(YES
m
PUSH) 
EXIT MENU (YES
m
PUSH)
Name of data
being called up
 previous next