Filter
Top Products
127
Troubleshooting
CF card
Symptom Cause/Solution
You cannot insert a CF card.
• You try to insert an unusable CF card (page 21).
• You are inserting it backwards. Insert it from the right side (page 23).
You cannot record on a CF card.
• The CF card is full. Delete unnecessary images (pages 46 and 99).
• An unusable CF card is inserted.
• The
/CF switch is set to . Set the switch to CF (page 21).
• The image size is set to [640(Fine)] when recording movies. Insert a “Memory Stick PRO” (pages
97 and 144) or set the image size to other than [640(Fine)].
You have formatted a CF card by
mistake.
• All the data on the CF card are erased by formatting. You cannot restore them.
PictBridge compliant printer
Symptom Cause/Solution
The connection cannot be
established.
• Consult with the printer manufacturer whether the printer is compliant with the PictBridge or not.
• Check that the printer is turned on and can connect with the camera.
• Set [USB Connect] to [PictBridge] in the SET UP settings (page 142).
• Depending on the circumstances, the connection may not be established. Disconnect and connect the
USB cable again. If an error message is indicated on the printer, refer to the operating instructions
supplied with the printer.
You cannot print images.
• The camera is not connected to the printer. Check that the camera and the printer are properly
connected using the USB cable.
• Turn on the printer. For further information, refer to the operating instructions supplied with it.
• If you select [Exit] during printing, you may not print again depending on your printer. Disconnect
and connect the USB cable again. If you cannot print still, disconnect the USB cable, turn off and on
the printer, then connect the USB cable again.
• Movies and images recorded in RAW mode cannot be printed.
• Images modifi ed with a computer or images shot using other than this camera may not be able to be
printed.
Printing is canceled.
• You disconnected the USB cable before the
(Not disconnect USB cable) mark disappears.
• You switched the
/CF switch while printing.