Filter
Top Products
Installation
Internal PSII
32
45537L-005 ZebraNet PrintServer II User Guide 04/21/2009
To install an internal PSII into a Z4Mplus printer, complete these steps:
1.
2.
3.
See Figure 8. Lift the media door and locate the screw in the middle of the hinge along the
top of the printer frame.
4. Remove the screw and the lock washer.
Figure 8 • Z4Mplus Media Door and Compartment
5. Close the media door.
Tools • You need these tools to complete this procedure:
Flat-blade Screwdriver Set 7 mm Nutdriver
Caution • Observe proper electrostatic safety precautions when handling
static-sensitive components such as circuit boards and printheads.
Connect yourself to an antistatic device.
Caution • Turn off (O) the printer and disconnect it from the power source before
performing the following procedure.
Turn off (O) the printer and disconnect the AC power cord and all data cables.
1
Media door
2
Lock washer
3
Screw
4
Electronics cover
3
4
1
2