Filter
Top Products
Getting Started
Before You Begin
44
45537L-005 ZebraNet PrintServer II User Guide 04/21/2009
Before You Begin
PSII offers many features, but how you access and work with them is dependent on your
environment. Before you begin, you need to get information from the
PSII configuration label.
To print a PSII configuration label, complete these steps:
1. Turn on (l) the printer and let it complete its power-up cycle.
2. Let the PSII complete its POST cycle.
3. When the above steps are complete, press Test and hold it in for a few seconds before you
release it.
• On the Z4Mplus and Z6Mplus, the Test button for the internal PSII device is a small
button on the back of the printer located under the RJ-45 connector. For more details,
see Figure 7 on page 31.
• On any other printer, the Test button on the PSII device is a small hole. For more
details, see Figure 4 on page 27.
A PSII configuration label prints. Your configuration label looks similar to Figure 13
on page 45.
Important • Make sure the printer is turned off (O).