Filter
Top Products
35
Installation
Internal PSII
04/21/2009 ZebraNet PrintServer II User Guide 45537L-005
9. See Figure 11. Insert the short ends of each standoff into the holes on the main logic board
until you hear a click.
Figure 11 • Z4Mplus Main Logic Board and Standoffs
10. See Figure 10 and Figure 11. From the electronics enclosure, plug the parallel port socket
of the
PSII board into the parallel port connector on the main logic board.
11. Align the holes in the PSII board with the standoffs and snap into place.
Be sure the
PSII is seated securely.
12. Does your printer have a PCMCIA card installed?
1
Parallel port connector on the main logic
board
2
Standoffs (3)
If… Then…
No a. With the PSII board connected to the main logic board, feed the connector
through the mounting slot in the back of the printer.
b. Continue with step 13.
Yes
a. With the PSII board connected to the main logic board, feed the connector
over the PCMCIA card, then through the mounting slot in the back of the
printer.
b. Continue with step 13.
2
1