Filter
Top Products
Installation
Internal PSII
36
45537L-005 ZebraNet PrintServer II User Guide 04/21/2009
13. See Figure 12. Place the I/O board inside the plate, and plug the cable into the connector
on the I/O board.
Figure 12 • Z4Mplus I/O Board and Plate
.
14. Using the screws removed in step 7, screw the plate onto the back of the printer.
15. Reinstall the electronics cover.
16.
If the green status indicator is solid (not blinking), the PSII has power.
17. Consult your System Administrator before configuring the PSII for your network. To
establish the network connection, refer to the section applicable to your network type.
1
Plate
2
I/O Board
3
I/O Board connector
Note • The parallel port on the back of the printer cannot be used when the internal PSII is
installed. The hardware of the PSII mounting bracket covers the parallel port.
2
3
1
Caution • Reconnect the printer to the power source and turn on (l).
Reconnect the AC power cord and all data cables and turn on (l) the printer.