Filter
Top Products
Custom Picture Settings
100
[Area B Revision]: Sets the amount of correction for area B.
[Level]: Adjusts the amount of correction to the color saturation. This setting can be adjusted from -50 to 50.
(Default: ±0)
[Phase]: Adjusts the amount of correction to the color phase. This setting can be adjusted from -18 to 18.
(Default: ±0)
[Other Functions]
[Setup Level]: Adjusts the black level set by the [Black] and [Master Pedestal] settings.
[Level]: Determines the amount of adjustment to be made. This setting can be adjusted from -50 to 50.
(Default: ±0)
[Press]: Compresses the dynamic range of the video signal so that it does not exceed 100%. Available options
are [On] and [Off]. (Default: [Off])
[Clip At 100%]: When the video signal exceeds 100%, this function clips the white level at 100%. Available
options are [On] and [Off]. (Default: [Off])
NOTES
• When an optional RC-V100 Remote Controller is connected to the camcorder, the following custom picture
settings can be changed using the buttons and dials on the remote controller. They cannot be changed from
the camcorder while the RC-V100 is connected.
- [Black] > [Master Pedestal]; [Black] > [Master Black] > [Red], [Blue]
- [Black Gamma] > [Level]
- [Knee] > [Slope] and [Point] (only when [Knee] > [Enable] is set to [On])
- [Sharpness] > [Level]
- [White Balance] > [R Gain], [B Gain]
COPY