Filter
Top Products
iDP3221 User’s Manual
92
CITIZEN
GSPxy
[Function] Specifying the basic calculation pitch
[Code] <1D>H<50>H<x><y>
[Range] 0 ≤ x ≤ 255
0 ≤ y ≤ 255
[Outline] This command sets the horizontal basic calculation pitch to approx. 25.4/x mm (1/x inches),
and the vertical basic calculation pitch to approx. 25.4/y mm (1/y inches).
• If x = 0, the horizontal basic calculation pitch is reverted to the default value.
• If y = 0, the vertical basic calculation pitch is reverted to the default value.
[Caution] • The horizontal direction is defined as the direction perpendicular to the paper feed, and the
vertical direction is defined as the paper feed direction.
• In Standard mode, the following parameters are used regardless of the character orientation
(e.g. inverted or turned 90°-right-turned).
(1) Commands using x:ESC SP, ESC S, ESC ¥, GS L, GS W
(2) Commands using y: ESC 3, ESC J
• In Page mode, the parameters used depend on the character orientation; as follows:
(1) If the start point specified by ESC T is the top left or bottom right (the characters are
mapped in the direction perpendicular to the paper feed).
•Commands using x: ESC SP, ESC $, ESC W, ESC ¥
•Commands using y: ESC 3, ESC J, ESC W, GC S,GS ¥
(2) If the start point specified by ESC T is the top right or bottom left (the characters are
mapped in the paper feed direction).
•Commands using x: ESC 3, ESC J, ESC W, GC S,GS ¥
•Commands using y: ESC SP, ESC $, ESC W, ESC ¥
• This command does not affect any other values that are already set.
• If calculations made for a combination with another command generate fractions, the
fractions are corrected with the minimum pitch of the mechanism, and the remainder is
omitted.
[Default] x = 180, y = 360
[See Also] "Page Mode" in Appendix 1
ESCSP,ESC$,ESC3,ESCJ,ESCW,ESC¥,GS$,GSL,GSW,GS¥