Filter
Top Products
iDP3221 User’s Manual
93
CITIZEN
GS V m ......... (1)
GS V m n ... (2)
[Function] Cutting the paper
[Code] (1) <1D>H<56>H<m>
(2) <1D>H<56>H<m><n>
[Range] (1) 0 ≤ m ≤ 1, 48 ≤ m ≤ 49
(2) 65 ≤ m ≤ 66, 0 ≤ n ≤ 255
[Outline] Cuts the specified paper.
"m" means the following.
m
Meaning
0,48
Full cut
1,49
Partial cut (leaving a bridge area uncut)
65
Paper feed by "cut position + {n×basic calculation pitch}×and full cut
66
Paper feed by "cut position + {n×basic calculation pitch}×and partial cut
(leaving a bridge area uncut)
[Caution] • In Standard mode, this command only works when it is entered at the beginning of a line.
For (1):
• A partial cut (leaving a bridge area uncut) is executed.
For (2):
• If n = 0, the paper is fed to the cut position, and then cut. If n≠0, the paper is fed by
"n×basic calculation pitch" inches past the cut position, and then cut.
• The basic calculation pitch is set by GS P.
The paper feed amount is calculated with the vertical basic calculation pitch (y). A
fractionresulting from the calculation is corrected with the minimum pitch of the
mechanism, and the remainder is omitted.