Filter
Top Products
iDP3221 User’s Manual
33
CITIZEN
8. DRAWER KICK-OUT CONNECTOR, POWER CONNECTOR
8.1 Drawer Kick-Out Connector
8.1.1 Specifications of Drawer Kick-Out Connector
(1) Drawer kick-out drive signal
Outputs a pulse specified with ESC p. The status of SW (+) can be checked with pin 34 on the parallel
interface connector, or with the DLE EOT, GS a, and GS r commands through the serial/parallel interface.
(2) Electrical characteristics
1) Drive voltage: 24 V DC
2) Drive current: 0.8 A at maximum (Within 510 ms)
3) Switch signal level: "L" = 0 to 0.5 V, "H" = 3 to 5 V
8.1.2 Connector's Pin Configuration
No. Signal Function
1 FG Frame Ground
2 DRAWER 1 Drawer 1 drive signal
3 DRSW Drawer switch input
4 VDR Drawer drive power
5 DRAWER 2 Drawer 2 drive signal
6 GND Common ground on the circuit
Connector used : TM5RJ3-66 (Hirose) or its equivalent
Applicable connector : TM3P-66P (Hirose) or its equivalent
CAUTION
: • No output is made while printing.
• The drawers 1 and 2 cannot be driven simultaneously.
• A solenoid used for the drawer should be of 36Ω or more. An output current should
be kept below 0.8 A. Use beyond this limit cannot be assured.
• This connector cannot be connected to a telephone line. Do not connect other than
the solenoid.
8.1.3 Drive Circuit