Digimerge DHU104 Security Camera User Manual


 
32
System Menu
SYSTEM MANAGEMENT
Factory Defaults
The System can be returned to the Factory
default settings:
• Select the ‘Factory Defaults’ option by
selecting the PRESS button.
• Login with your user ID and password.
• Choose OK to reset the unit, or
CANCEL to exit without resetting.
NOTE: If the System is reset to Factory
Defaults, all settings will be lost (except the
Date and Time).
System Data
The System settings can be saved to a
USB flash drive:
• Insert the USB flash drive into the
System and select the Save option to
save settings:
• A Success message indicates that the
backup was completed.
• If the device is not detected, a message
will indicate that No storage device was
found.
• Insert the USB flash drive into the
System and select the Load option to
restore settings.
• This is recommended after initial setup
and installation is complete.
CONTROL DEVICE
Used with an external control device (not
included with the system):
System ID - Select system ID. (1~254)
Protocol - Select protocol (from the
Device user Manual).
Baud rate - Setup baud rate (from the
Device user Manual).