68
Appendix 13: Setting Up Remote Viewing
Appendix 13: Setting Up Remote Viewing
Setting up the Remote Viewing Feature requires several steps. Networking skills are required to
correctly configure the remote viewing functions.
What do I need?
• The DVR System
• A PC with the installed DigiClient software (refer to the DigiClient Software Manual for
installation instructions)
• A router (not provided with the system) and High Speed Cable or DSL Internet Connectivity
(for remote viewing outside your network)
Network Setup / Remote Access Overview
To setup remote viewing:
1. With the system powered off, connect the system to the router using the included Ethernet
cable.
2. Power the system on. You must connect the system to the router prior to turning on the
system. This allows the system and router to communicate over the network.
3. Press and hold the Enter button on the front panel to find your system's IP address.
4. Enable Port Forwarding on your router. Refer to the included Router Guide and Basics of
Remote Video Access Guide for further assistance with your specific network setup and
hardware.
5. Setup an account at http://ddns.digimerge.net
ROUTER
(Not Included)
INTERNET
PC
(Not Included)
DVR