Filter
Top Products
20
Internet Explorer Setting
Camera Page (continued)
* The [Set values] in bold letters are factory defaults.
Settings (continued)
C Brightness Adjusts the brightness of an image.
Increasing the value brightens dark areas, and decreasing the value makes
bright areas more pleasing to the eye.
[Set values: 5 to Normal to 5]
D Color Level Adjusts the color level.
A larger value increases the darkness of color, but a smaller value
decreases the darkness of color.
[Set values: 5 to Normal to 5]
E Black Level Adjusts the black level. Setting the value to "Low" darkens the video image.
[Set values: Low, Normal]
Memo:
● If the black level is set to ALowB, this may be too low depending on the
monitoring device, or dark area will become complete black.
● When using the Monitor Output or H.264/MPEG-4 images, set it to
"Normal".
F Gamma
To alter the appearance of dark areas in a video image, adjust the gamma curve.
ON : Perform gamma correction.
OFF : Do not perform gamma correction. The entire image appears dull.
[Set values: ON, OFF]
G Enhance Level Sets the intensity of edge enhancement.
A larger value increases the intensity of edge enhancement, but a smaller
value decreases the intensity of edge enhancement.
[Set values: 5 to Normal to 8]
H 3D DNR The noise on the screen will be reduced.
[Set values: OFF, Low, Mid, High]
Memo:
● With a moving object, the higher the noise reduction (as you select Low -
Mid - High), the more likely there will be an afterimage.
● You cannot select this when the frame rate is set to 25 fps or higher.