Filter
Top Products
37
* The [Set values] in bold letters are factory defaults.
B 1st Trigger Select the 1st trigger to perform an action.
[Set values: Pin Input1 Make, Pin Input1 Break, Pin Input2 Make, Pin
Input2 Break, Position, Audio Detection1, Audio Detection2
(VN-H57U/H257U/H257VPU/H157WPU only), Motion
Detection, Tampering Detection, Black & White, Day/Night,
Time]
Memo:
● If you set the [2nd Trigger] to "Disable", an action will be performed when
only [1st Trigger] is triggered. (VN-H57U/H257U/H257VPU/H157WPU
only)
● When "Motion Detection" or "Position" is selected for the [1st Trigger]
trigger, [Max. Interval] and [2nd Trigger] cannot be selected. (VN-H57U/
H257U/H257VPU/H157WPU only)
● "Time" can be specified only when the action is "Switch Scene File".
C Max. Interval
(VN-H57U/
H257U/H257VPU/
H157WPU only)
This is available when both [1st Trigger] and [2nd Trigger] are set.
Specify the maximum interval between each trigger for [1st Trigger] and [2nd
Trigger].
An action will be performed if [2nd Trigger] occurs within the maximum time
interval after [1st Trigger] occurs.
[Set values: 1 - 3600] sec
D 2nd Trigger
(VN-H57U/
H257U/H257VPU/
H157WPU only)
Select the 2nd trigger to perform an action.
[Set values: Disable, Pin Input1 Make, Pin Input1 Break, Pin Input2 Make,
Pin Input2 Break]
E Mail Mail Settings : If you have set the [SMTP Server], [Port Number], and
[Sender Mail Address] on the [Alarm Environment]
page, the AConfiguredB message is shown. If not set,
the ANot configuredB message is shown. For details
about the mail setup, refer to "Alarm Environment
Page". (A Page 40)
Mail Address : Enter the recipient's mail address.
Mail Text : Enter the mail text. You can enter text consisting of up
to 127 alphanumeric characters. Or a text of up to 63
dual-byte characters can be entered.
JPEG Attachment : Specify whether or not to attach an image file to the
mail. To attach JPEG images, check the Attach box and
select the transmission channel.
Encoder : Specifies an Encoder No. for encoding of attached
JPEG files.
Memo:
● You cannot select [Attach JPEG] if there is no channel with Encode set to
JPEG.