Filter
Top Products
53
Memo:
● Press the [OK] button to enable the new settings.
● When camera images are acquired by the Built-in Viewer or another client and if this acquisition
exceeds the distribution capability of camera, the video images may not appear on the Privacy Mask
page. When you use the Privacy Mask page, turn the Built-in Viewer and another client Off.
● If the [OK] button is pressed upon entering an invalid value, a warning message will appear and the
entry will be denied. Press the [Cancel] button to restore the invalid entry to the value before the
change was made. If you press the [Cancel] button, other changed items will also be restored to the
values before the change was made.
● The privacy mask that you set also works for the monitor output.
Note:
● Masks cannot be set in a zoomed screen.
● When you open the Privacy Mask settings page, it is displayed in the fixed (full-screen) size. The
size of the mask you have set changes when you zoom.
* The [Set values] in bold letters are factory defaults.
A Mask The screen is divided into 46 (horizontal) by 34 (vertical) blocks (for aspect
ratio 4:3) or into 60 (horizontal) by 34 (vertical) blocks (for aspect ratio
16:9). You can specify the positions to be masked in each block.
B Privacy Mask Turns the Privacy Mask function ON or OFF.
[Set values: ON, OFF]
C Brightness Sets a brightness of Privacy Mask areas.
When a large value is set, the brightness level increases (becomes white).
When a small value is set, the brightness level decreases (becomes dark).
This setting is common to all blocks.
[Set values: 0 to 4 to 8]
D All Mask Enables all the privacy masks. Press the [OK] button to enable this setting.
E Clear Mask Releases all the privacy masks.