Filter
Top Products
68
Internet Explorer Setting
Access Restrictions Page
This page sets the client restrictions.
This page can be used during access using AadminB.
Memo:
● Press the [OK] button to enable the new settings.
● If the [OK] button is pressed upon entering an invalid value, a warning message will appear and the
entry will be denied. Press the [Cancel] button to restore the invalid entry to the value before the
change was made. If you press the [Cancel] button, other changed items will also be restored to the
values before the change was made.
● This function applies to H.264, JPEG or MPEG-4. This function does not restrict the access via the
Web browser and the use of API.
Note:
● The Access Restriction function determines the restrictions when TCP connection is made by the
client. If the TCP connection is already established to the client, this TCP connection is not released
even when you sets the access restrictions after the connection.
Settings (continued)
B
A
Click [Advanced Settings] and [Access Restrictions].
Client Address You can restrict a client to allow access to the camera using its IP address.
A Address
Restriction
If "Deny" is selected, retrieving H.264, JPEG or MPEG-4 by the IP address
set in [IP Address] option will be denied. An access to the Settings page is
not restricted.
If "Allow" is selected, retrieving H.264, JPEG or MPEG-4 by the IP address
set in [IP Address] option will be permitted. An access to the Settings page is
not restricted.
[Set values: Deny, Allow]
B IP Address Up to 10 blocked or permitted client IP addresses can be registered.