Filter
Top Products
41
* The [Set values] in bold letters are factory defaults.
A Mail Settings
(VN-H57U/H257U/
H257VPU/H157WPU
only)
For setting the mail options when [Mail] is selected as the action on the
Alarm page. If an SMTP server, a port number or a sender's mail
address has been set, "Preset" will be displayed.
SMTP Server Sets the IP address or FQDN of the SMTP server.
Memo:
FQDN (Fully Qualified Domain Name)
This refers to a domain name that has been completely specified, without
abbreviation of the host or domain names on a TCP/IP network.
For example, with a host name of www and a domain name of
victor.co.jp, the FQDN representation is "www.victor.co.jp".
Japanese cannot be used in a FQDN. If you have configured an FQDN,
configure a DNS server on the Network Basic page as well. (
A
Page 59)
Port Number Enter the port number.
[Set values: 0 - 110 - 65535]
Send Mail Address Set the sender's mail address.
POP
before
SMTP
To enable [POP before SMTP], select "Enable" and set up the POP server.
POP
Server
Sets the IP address or FQDN of the POP server.
Port
Number
Enter the port number.
[Set values: 0 - 110 - 65535]
User
Name
Enters a user name.
Password Enters a password.
B Alarm output Configure settings related to alarm output from an alarm output cable or
connector.
Duration
Sets the output duration for [Manual Output].
[Set values: 0/ 100 - 1000 - 5000] msec
Manual Output
Manually operate alarm output.
The current output status is displayed on the right side. When [Duration]
is set to "0", pressing the [Make] button sets the alarm to make output,
and pressing the [Break] button sets the alarm to break output.
When [Duration] is set to other than "0", pressing the [Make] button sets
the alarm to make output only for the output duration time, and then
changes it to break output.
When [Duration] is set to other than "0", pressing the [Break] button sets
the alarm to break output only for the output duration time, and then
changes it to make output.