Filter
Top Products
32
Internet Explorer Setting
Encoding Page (continued)
* The [Set values] in bold letters are factory defaults.
Settings (continued)
C Multi-Encode2 (continued)
Encoder
No.2
Encoding
Display
Displays the "MPEG4" encoding selected for Multi-Encode2.
Framesize Displays the frame size selected for Multi-Encode2.
Framerate Specify the frame rate for Multi-Encode2.
[Set values: 15 fps, 10 fps, 7.5 fps, 1 fps]
Bitrate Select whether to set the control rate mode for encoding to CBR
(Constant Bit Rate) or VBR (Variable Bit Rate).
CBR : Data is encoded at a fixed bit rate regardless of the condition of
input video signals. It is easy to estimate the bit rate. Select
from the list of bit rate ranges.
VBR : The bit rate varies according to the condition of input video
signals. The picture quality is stabled but it is difficult to
estimate the bit rate. Select from the list of bit rate ranges.
[Set values: CBR, VBR]
Bit rate range
[Set values: 64, 128, 256, 384, 512, 768, 1024, 1536, 2048, 3072, 3584,
4096, 8192] kbps
I Frame
Interval
Select the I-frame interval. Encoding starts from the I-frame. Shortening
the interval stabilizes the picture quality even when there are rapid
changes in the video image; however, the picture quality for images with
little change will deteriorate. In addition, when multicast packet loss
occurs, the time interval required to restore the image is shorter.
[Set values: 15, 30] Frame
D Monitor Output Sets monitor output.
[Set values: ON, OFF]
Memo:
● To turn the monitor output ON, set the following in the [Single-Encode]
(JPEG/H.264 Baseline/H.264 High) option:
• Aspect ratio = 16:9
• Frame size = 1920 x 1080
• Frame rate = 5 fps or less
● If you changed the setting of the camera’s monitor selection switch,
you need to restart the camera.