Filter
Top Products
Safety Precautions for Inspection and Service
1
3
7. Do not touch a high-temperature part.
8. Make a ground connection at all times
(This item may not be effected in USA).
9. Do not remodel the product.
10. Restore all parts and harnesses to their original positions.
• A part marked with the symbol shown on the left and other
parts such as the exposure lamp and fusing roller can be
very hot while the machine is energized. Touching them
may result in a burn.
• Wait until these parts have cooled down before replacing
them or any surrounding parts.
• Be sure to connect a ground wire to the ground terminal
even when performing an inspection or repair. Without
proper grounding, electrical leakage could result in an
electric shock or fire.
• Never connect the ground wire to a gas pipe, water pipe,
telephone ground wire, or a lightning conductor.
• Modifying this product in a manner not authorized by the
manufacturer may result in a fire or electric shock. If this
product uses a laser, laser beam leakage may cause eye
damage or blindness.
• To promote safety and prevent product damage, make
sure the harnesses are returned to their original positions
and properly secured in their clamps and saddles in order
to avoid hot parts, high-voltage parts, and sharp edges, or
being crushed.
• To promote safety, make sure that all tubing and other
insulating materials are returned to their original positions.
Make sure that floating components mounted on the
circuit boards are at their correct distance and position off
the boards.