Panasonic AJ-P2C064AG Camera Accessories User Manual


 
17
Parts and their Functions: Audio (input) Function Section
Parts and their Functions
1. MIC IN (microphone input) jack (XLR, 5-pin)
A microphone (optional) is connected here. Power can
be supplied via this jack to allow use of a phantom
microphone. Note that the FRONT MIC POWER menu
option must be set to “ON” when using a phantom
microphone.
These options are found in the <MIC/AUDIO2> screen
on the MAIN OPERATION page.
2. AUDIO LEVEL CH1/CH2 (audio channel 1 & 2
recording level adjustment) controls
With the 3. AUDIO SELECT CH1/CH2 switch positioned
to [MAN], these controls can be used to adjust the
recording levels for audio channels 1 and 2.
Note that the controls are designed to be locked. For
adjustment, each control must be depressed while
turning.
3. AUDIO SELECT CH1/CH2 (audio channel 1 & 2
automatic/manual level adjustment selector)
switch
Use this switch to select recording level control mode for
audio channels 1 and 2.
AUTO: Recording level automatically controlled.
MAN: Recording level manually controlled.
4. AUDIO IN (audio input selector) switch
Use this switch to select the signals recorded through
audio channels 1 - 4.
FRONT: Signal from the microphone connected to the
1. MIC IN jack is recorded.
W.L. (WIRELESS):
Signal from the slot-in wireless receiver is
recorded.
REAR: Signal from the audio device connected to the
5. AUDIO IN CH1/CH2 connector is recorded.
Note
When you use stereo microphone (AJ-MC900G,
optional), set both CH1 and CH2 to [FRONT]. The
signal from L CH is recorded to CH1 and that from R CH
to CH2.
5. AUDIO IN CH1/CH2 (audio input channel 1 & 2)
connectors (XLR, 3-pin)
Audio devices or a microphone may be connected here.
6. LINE/MIC/+48V (line input/mic input/mic input
+48 V) selector switch
Used to select the audio signal input from the 5. AUDIO
IN CH1/CH2 connectors.
LINE: Audio signal line-input from the audio device
is input.
MIC: Audio signal from a self-powered (active)
microphone is input. (Power for a phantom
microphone is not supplied to the microphone
from the unit.)
+48V: Audio signal from a passive microphone is
input. (Power for a phantom microphone is
supplied to the microphone from the unit.)
7. Wireless slot
A Unislot wireless receiver (optional) may be attached
here.
8. FRONT AUDIO LEVEL (audio recording level
adjustment) control
This control adjusts the recording levels for audio
channels 1 and 2.
However, when the 3. AUDIO SELECT CH1/CH2 switch
is set to [AUTO], the level will adjust automatically and
the 2. AUDIO LEVEL CH1/CH2 knob and this knob will
not be active.
The control can be enabled or disabled through the
menu options FRONT VR CH1 or FRONT VR CH2.
These options can be found in the <MIC/AUDIO1>
screen on the MAIN OPERATION page.
Audio (input) Function Section
1
12
11
13
14 10
3
7
2
6
5
9
815
4
AJ-HPX3700G-VQT1V68_eng.book 17 ページ 2008年10月15日 水曜日 午後6時38分