Panasonic AJ-P2C064AG Camera Accessories User Manual


 
35
Recording and Playback: Basic Procedures
Recording and Playback
For shooting, follow the steps below.
1 Select a filter according to light conditions.
2 When the white balance is saved:
Position the WHITE BAL switch to [A] or [B].
When the white or black balance is not saved and
you have no time to adjust the white balance:
Position the WHITE BAL switch to [PRST].
This adjusts the white balance against the filter
according to the position of the FILTER control.
If the white balance is adjusted on the spot:
Position the WHITE BAL switch to [A] or [B] and shoot a
white test subject so that it appears at the center of the
screen. Then, follow the steps below to adjust the white
balance.
1 Press the AUTO W/B BAL switch toward [AWB] to
adjust the white balance.
2 Press the AUTO W/B BAL switch toward [ABB] to
adjust the black balance.
3 Press the AUTO W/B BAL switch toward [AWB] to
adjust the white balance again.
For directions on making adjustments, see [Adjusting
the White Balance] (page 52) and [Adjusting the Black
Balance] (page 55).
3 Point the camera at your subject to adjust the focus, and
zoom.
4 To use the electronic shutter, set the shutter speed and
operation mode.
For more information, see [Setting the Electronic
Shutter] (page 56).
5 Press either the REC START button or VTR button at
the lens to start recording.
During recording, the REC lamp in the viewfinder stays
illuminated.
6 To stop recording, press either the REC START button
or VTR button at the lens.
The REC lamp in the viewfinder goes out.
White/Black balance adjustment to recording completion
White/Black Balance Adjustment to Recording Completion
Operation Buttons
During recording, all operation buttons (REW, FF, PLAY/
PAUSE, STOP) are disabled.
132245, 6
AJ-HPX3700G-VQT1V68_eng.book 35 ページ 2008年10月15日 水曜日 午後6時38分