Filter
Top Products
57
Adjustments and Settings for Recording
: Setting the Electronic Shutter
Adjustments and Settings for Recording
The shutter speed in any shutter mode is set using the
SHUTTER switch.
In SYNCHRO SCAN/SYNCHRO SCAN2 mode, shutter
speed can be switched easily, using the SYNCHRO SCAN
adjustment buttons (+/–) on the side panel.
Note that the range of selectable shutter speeds may be pre-
defined; whether or not to use the SYNCHRO SCAN mode
may be determined through the <SHUTTER SPEED> and
<SHUTTER SELECT> screens. These screens are found in
the CAM OPERATION page.
The selected shutter speed is retained even if the unit is
turned off.
1 Press the SHUTTER switch, positioned at [ON], towards
[SEL].
a. SHUTTER switch
2 Once more, press the SHUTTER switch towards [SEL].
Repeat this switchover until the desired mode or speed
appears in the viewfinder screen.
If all modes and speeds are available, the display
changes in the following order:
See [Viewfinder Screen Status Displays] (page 76).
Note
When recording using VFR, set the shutter speed to 1/60 or
1/100 to allow the recording to continue without any change
in brightness when the frame rate is changed mid-way
through recording.
Setting the Shutter Mode and Speed
a
Viewfinder displays relating to the shutter
POSITION1 POSITION2 POSITION3 POSITION4 POSITION5 POSITION6
Normal mode
SYNCHRO SCAN
mode
SYNCHRO SCAN2
mode
AJ-HPX3700G-VQT1V68_eng.book 57 ページ ２００８年１０月１５日 水曜日 午後６時３８分